METHOD OF APPLICATION:

Everlast Metals SSL-175 panels must be installed in a sequential pattern. Application of a Everlast Metals approved underlayment prior to panel installation is recommended when installed over a solid substrate.

DESCRIPTION:

The Everlast Metals SSL-175 Snap Seam Standing Seam roofing panel utilizes snap together panels for quick installation and no field seaming required.

Installed over solid decking, this design allows for expansion & contraction caused by natural elements, providing a virtually leak proof roof with exceptional UL580 and ASTM E1592 wind uplift ratings.

The panel is available in a wide variety of materials and finishes including Trinar coated G-90 Galvanized Steel, Galvalume® Steel, and Aluminum, as well as Copper and Zinc.

An optional thermally applied pre-assembly in-seam sealant is available. The minimum slope requirement for an Everlast Metals Watertight Warranty is 2:12

PRODUCT DATA:

 Storage

Everlast Metals metal panels should be stored in a well-ventilated, dry place where no moisture can contact them. Moisture (from rain, snow, condensation, etc.) trapped between layers of material may cause water stains or white rust, which can affect the service life of the material and will detract from its appearance. If outdoor storage cannot be avoided, protect the panels with a ventilated canvas or waterproof paper cover. Do not use plastic, which can cause condensation. Keep the material off the ground in an inclined position with an insulator such as wood. Protective film may degrade or become brittle with long-term exposure to direct sunlight.

Panel Size

Panel Width: 12"-18"

Seam Height: 1.75”

Min. Panel Length: 2.0’

Max. Panel Length: 50’ (Longer lengths require on-site rollforming)

Testing

ASTM E72

ASTM 1592

ASTM E1680

ASTM E1646

UL 790

UL 580